Hỗ trợ cho SDX900
- Mat, Cutting Blade and Material Combinations
- Troubleshooting about the Mat
- If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
- Can rough material be cut?
- Can different types of material be attached to the same mat for cutting?
- Can the Cutting mat or Scanning mat for the ScanNCut (CM series) be used in the ScanNCut DX (SDX series)?
- Can multiple sheets of material be overlapped and attached to the mat? Xem thêm Ẩn đi
- Mat, Cutting Blade and Material Combinations
- Troubleshooting about the Mat
- If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
- The mat cannot be recognized.
- When the mat is inserted, the attached material peels off.
- The mat cannot be fed out.
- The material to be cut/drawn or original to be scanned cannot be attached to the mat.
- The mat is fed in at an angle.
- The mat cannot be inserted. Xem thêm Ẩn đi
Các câu hỏi khác
Hướng dẫn truy cập những câu hỏi phổ biến nhất